| 0 | 0 | ||
Hi. I’m getting back into my modular after a move and other pesky life interferences. I’ve just noticed that my Rene 2 is outputting gate (and access) CV despite deselecting various steps. I’ve seen this behavior in X and Y gates (haven’t tested C).
I believe that I have the latest firmware installed. There is a Tempi on the select bus but I didn’t think this should affect the output.
Does anyone have any advice? I greatly appreciate it.
[link] [comments]
![[-]](http://www.n01ze.com/synthwizards/Forum/images/Carbon/collapse.png "[-]")
