Digital module initial power draw

[SynthWizard]

0			0

Digital module initial power draw

Moved a digital module from one space to another in a case with more than reasonable headroom and I see faint smoke ( module was in my hand so i literally saw the smoke and shut down immediately). Restart the system without the module and test the system and all is well. So i literally power down and restart with module plugged in as the case started up, and watch close as to see what happened and so on because maybe smoke could be a waft from wife’s vape or something, I see nothing out of sorts given the variables at hand, the digital modules position in the same case etc… and the interface works fine, but the gates and cv are waaaaaaaayyy out of calibration. No smoke either and all menus and are fine just the analog portion seems to be affected. I study the back and see two caps are slightly convex, so seems to be the only visually diagnosable problem i can see. Anyone have any idea of what could have happened????

submitted by /u/LBbronson
[link] [comments]