Rate or roast my rig!

[SynthWizard]

0			0

Rate or roast my rig!

So I've gotten to the point where I had to put my beloved Neutron back in it's original enclosure, and managed to get it (albeit a bit awkwardly) sitting on top of my 9U case so that it still feels like a part of the system. This was done because I needed the space and power for a couple of other modules I've been wanting to add and had ordered.

So for the first time in a while, I have relatively significant blank spaces in my case, but I figure this is as good a time as any to ask for some feedback or advice regarding the current setup - what would you get rid of, add, change or rearrange here?

https://www.modulargrid.net/e/racks/view/1764195

I'm currently eyeing both the Belgrad filter and the Odessa oscillator from XAOC Devices, another Ornament and Crime (8hp, same as the one I've got) and some offset preset-based macro controller module (i.e. if and when the Emblematic Systems Catalyst Flow is seen in stock anywhere, or the second best being the Ellis from Livestock Electronics).

​

Also any questions are welcome.

PS the Quad VCA, Squawk Dirty and Maze are on their way here, have not installed them yet

submitted by /u/Ipsilon_Havel
[link] [comments]